Sand boil
Sand boils, sand volcanoes, or sand blows occur when water under pressure wells up through a bed of sand.[1] The water looks like it is boiling up from the bed of sand, hence the name.
Sand volcano
[edit]
A sand volcano or sand blow is a cone of sand formed by the ejection of sand onto a surface from a central point. The sand builds up as a cone with slopes at the sand's angle of repose. A crater is commonly seen at the summit. The cone looks like a small volcanic cone[2] and can range in size from millimetres to metres in diameter.
The process is often associated with soil liquefaction and the ejection of fluidized sand that can occur in water-saturated sediments during an earthquake. The New Madrid Seismic Zone exhibited many such features during the 1811–12 New Madrid earthquakes.[3] Adjacent sand blows aligned in a row along a linear fracture within fine-grained surface sediments are just as common, and can still be seen in the New Madrid area.
These earthquakes also caused the largest known sand boil in the world, which can still be found near Hayti, Missouri en is locally called "The Beach".[4] It is 2.3 kilometers long and covers 55 hectares.
In the past few years, much effort has gone into the mapping of liquefaction features to study ancient earthquakes.[5] The basic idea is to map zones that are susceptible to the process and then go in for a closer look. The presence or absence of soil liquefaction features, such as clastic dikes, is strong evidence of past earthquake activity, or lack thereof.
These are to be contrasted with mud volcanoes, which occur in areas of geyser or subsurface gas venting.
Flood protection structures
[edit]Sand boils can be a mechanism contributing to liquefaction and levee failure during floods. Boil refers to the visible "boiling" movement of coarse sand grains retained in the hole even as finer particles (silts and fine sands) are carried out and deposited on the apron around the boil hole. Sand boils are caused by hydraulic head in levee or dike pushing the water to seep out the other side, most likely during a flood. Sand boils start as simple seeps of laminar flow. With increasing head from rising flood waters, turbulent flow will initiate where the laminar flow leaves the soil to flow freely. Turbulent flow produces soil piping, whereby the removal of soil particles results in a pipe-shaped cavity through the embankment, initiating at the seep and working through the embankment back to the water source. Once initiated, an unmitigated soil pipe can proceed quickly to embankment failure.
The flow in a sand boil can be slowed, but it is impractical to stop completely. The most effective response to an active sand boil is to stand water over the boil deep enough to reduce the hydraulic gradient and slow the water flow to eliminate the turbulence and internal erosion at the head of the pipe. Slower, nonturbulent flow will not be able to move soil particles. The suppressing depth of water is often created with sandbags forming a stacked ring around the boil.[6]
During the flood of spring 2011, the United States Army Corps of Engineers had to work to contain the largest active sand boil ever discovered. The sand boil measured nine by 12 meters (30 by 40 feet) and was located in the city of Cairo, Illinois, at the confluence of the Mississippi River and the Ohio River.[7]
Earthquakes
[edit]An example of this is during the 1989 earthquake in San Francisco when sand boils brought up debris from the 1906 earthquake. This process is a result of liquefaction. By mapping the location of sand boils that erupted in the Marina District during the 1989 Loma Prieta earthquake, scientists discovered the site of a lagoon that existed in 1906. The lagoon developed after the Fair's Seawall was constructed and was later filled in in 1915 in preparation for the Panama–Pacific International Exposition.[8]
See also
[edit]References
[edit]- ^ "Christchurch Earthquake – An Overview". Institution of Professional Engineers New Zealand. March 2011.
- ^ [1] Images after 2010 Canterbury earthquake
- ^ "Historic Earthquakes: New Madrid Earthquakes 1811–1812". United States Geological Survey. Retrieved March 7, 2010.
- ^ "Strange Happenings during the Earthquakes". United States Geological Survey. Retrieved October 13, 2024.
- ^ Crone, Anthony J; Wheeler, Russell L (2000). "Data for Quaternary Faults, Liquefaction Features, and Possible Tectonic Features in the Central and Eastern United States, East of the Rocky Mountain Front". United States Geological Survey. Open-File Report 00-0260.
- ^ UC Davis, Department of Civil & Environmental Engineering: Photograph of sandbag ring Archived June 11, 2010, at the Wayback Machine
- ^ wpsdlocal6.com Archived May 4, 2011, at the Wayback Machine
- ^ Bardet, J.P.; Kapuskar, M. (1991). "The Liquefaction Sand Boils in the San Francisco Marina District During the 1989 Loma Prieta Earthquake". Conference Proceedings, Second International Conference on Recent Advances in Geotechnical Earthquake Engineering & Soil Dynamics (Paper 19).